Assembling PC is simple but we should be careful about it. First check your purchased components like Processor, Ram, Hard disk, Mother board, Processor Fan (Heat sink fan), Monitor, CD/DVD Drive, Keyboard and Mouse and all the Cables. Now take your cabinet and put it down by Right side, because mostly the door is present in the Left side only. First of all you have to check your Processor, Ram and Motherboard while purchase itself. Ask your retailer to check it out by fixing the processor and ram with the mother board and run the system by connecting a monitor from there and perform the BIOS-POST (Power On Self Test) to check whether it is ok or not. Now you can confirm that every thing is ok.
Now you are having the mother board is fixed with Processor, Ram, and Heat sink fan and then now you fix your Motherboard to the cabinet. While fixing you should by very careful, because the board is having lot of ICs, pins, ports etc. and if any of one is damaged, then the entire system will not work and it doesn’t covers Guarantee. Now you place the Motherboard slowly in the base of the cabinet and locate the wholes to screw it up.
Now you are having the SMPS is in the top of cabinet and it is having lot of wires. Now connect the wires to the board, we can easily identify by the size. The largest one (bunch of wires) is connected to the board and like that to the hard disk. Now connect the USB cables and power/reset cables in the correct pin which is referred from the mother board manual. Then you fix CD/DVD drives from the front after removing the small doors. Assembling is mostly finished.
The Remaining things are to connect the cables to back side of the cabinet in the given ports for Monitor, Keyboard, Mouse, Power cable. After that close the cabinet to complete the assembling and now the PC is assembled.
Now you are having the mother board is fixed with Processor, Ram, and Heat sink fan and then now you fix your Motherboard to the cabinet. While fixing you should by very careful, because the board is having lot of ICs, pins, ports etc. and if any of one is damaged, then the entire system will not work and it doesn’t covers Guarantee. Now you place the Motherboard slowly in the base of the cabinet and locate the wholes to screw it up.
Now you are having the SMPS is in the top of cabinet and it is having lot of wires. Now connect the wires to the board, we can easily identify by the size. The largest one (bunch of wires) is connected to the board and like that to the hard disk. Now connect the USB cables and power/reset cables in the correct pin which is referred from the mother board manual. Then you fix CD/DVD drives from the front after removing the small doors. Assembling is mostly finished.
The Remaining things are to connect the cables to back side of the cabinet in the given ports for Monitor, Keyboard, Mouse, Power cable. After that close the cabinet to complete the assembling and now the PC is assembled.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.